At the Embedded Systems Conference, Allan Yogasingam and Steve Bitten, technical analysts for EETimes and TechInsights, did live teardowns on the Apple Newton MessagePad and Bandai-Apple Game Console of the 1990s. Both products combined leading-edge ICs with older ones (some of which are still made!), and their failures in the market have lessons that still apply--and some that don't.
The Newton, developed in 1992 and released in 1993 was the first personal digital assistant (PDA), and combined calendar, notepad, a 9600 baud fax/modem, and similar basic features with notepad-like handwriting recognition capability. By our standards, it was quite a handful, approximately twice the size of a modern PDA.
Inside the unit was an Am610 processor, a cutting-edge 32-bit RISC unit. It was supported by 4 MB of AMD ROM, Epson RAM, an Intel 8 MB flashfile memory (used in lieu of additional static RAM), and a 12-bit analog/digital converter from Analog Devices. The back of the single PCB was mostly analog circuitry, while the front was primarily digital. An RS-422 line driver and a dc/dc switching regular, both from Linear Technology Corp., rounded out the bill of materials.
But a product is more than its BOM. Although there are Newtons still in use, and even user groups for it, the PDA was a failure, most likely for these reasons, according to Yogasingam:
Development of the Newton took between three and four years, and Apple suffered a serious "black eye" in the market and red ink as a result of it. But there were some positive outcomes: its operating system was sold to Palm, and became the basis of the Palm Pilot OS, and it put end-users on the road to non-QWERTY portable devices as a product line. Since it consumed so much of Apple's R&D resources, set such high (and unrealistic expectations), and fell so flat, it also cost John Scully his job as Apple CEO.
The back of the console has an array of connectors. In addition to the TV/monitor interface connectors, it had connections for its 14.4 kbps modem, a printer port for the Pippin printer, and an S-video output. The PCB was housed in a metal enclose within the outer plastic housing, for RFI shielding. ICs included a 32-bit Motorola 603 PowerPC clocked at 66 MHz, already relatively underperforming compared with other available processors; a Brooktree (then sold to Rockwell, then Conexant) digital video encoder, and RGB to NTSC/PAL encoder, Samsung DRAM, an audio codec from Crystal Semiconductor (now part of Cirrus Logic), a Zilog SC controller, AMD Flash ROM, a Texas Instruments I/O controller, and two I/O controllers from VLSI--a fairly large and costly BOM and associated assembly.
There was also a slot for expansion memory, but users would, in theory, need to have this installed by a dealer, since access was difficult, with lots of screws and parts to remove, as Yogasingam and Bitten struggled to find and remove the many impediments to disassembly. The failure of the Apple-Bandai console came quickly:
Bill Schweber is the site editor of Planet Analog. You may contact Bill at bschweber@techinsights.com.