Building a really low-cost sweeper -

Building a really low-cost sweeper

I needed to make a really low-cost swept frequency tone generator using just some spare op-amp sections and no parts that were sole source. Fortunately, the sweep requirements weren't terribly critical. There was no particular linearity requirement and the frequencies were only low to mid audio range. I just needed to have a minimum frequency ratio from low to high of at least two to one.

I made the thing using TL082 op-amps and all went well. Unfortunately though, this happened so long ago that I lost my notes on what the exact design had turned out to be and thereby learned first-hand the true meaning of personal memory loss.

However, the gist of what I did is seen in the following SPICE simulation.

Cheap sweep oscillator

One small caveat not shown in this simulation is that the TL082 op-amps needed 1K pull-up resistors from their outputs at U1 (the sweep oscillator) and U4 (the swept oscillator) to the positive rail to ensure that this thing would always start-up.

It did. The production run was approximately 500 units.

Also see :

Originally published on Embedded's sister site, EDN: “Cheap sweep.”

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.